![]() The size of the panels is just right for spanning the width of two 3-foot wide garden beds with a 2-foot wide path in between. It’s also effective for medium-weight perennial vines, such as hops, passion fruit and climbing roses. This version works for heavier annual vines like cucumbers, squash and tomatoes. Tunnel Trellisĥ-foot metal T-posts (four for each livestock panel used) Hang the panel on the hooks and plant the vines directly below it.Set the panel down and screw a 3-inch metal hook into each of the holes.Repeat the process along the bottom of the panel, drilling the holes just below the bottom wire. Drill a 1/8-inch hole just inside the top corners of the panel and every four feet between the two corners.Get two friends to hold the livestock panel flat against the wall about 6 inches off the ground.Use it on any exterior wall – house, barn or shed – that you don’t mind drilling a few holes into. It’s also a good choice for supporting ‘cane’ fruits, such as blackberries and raspberries. This version is best for lightweight annual vines like peas, beans, nasturtiums or gourds. ![]() Here are three ways to use them to make a trellis. The wider spacing coupled with beefier wires makes hog panels more aesthetically attractive than wire mesh fencing, so it is often used in landscaping projects. The spaces between the wires are large compared to mesh fencing – usually 4 inches by 4 inches or 6 inches by 6 inches. ![]() Technically, only the shorter panels are for containing pigs, while the taller versions are often labeled as sheep or cattle panels. The panels are typically sold in 16-foot lengths at feed stores and range from 34 inches to 50 inches in height.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |