If you select Flannel, you must set Pod CIDR Block. For each vSwitch that allocates IP addresses to worker nodes, you must select a vSwitch in the same zone to allocate IP addresses to pods. If you select Terway as the network plug-in, you must select vSwitches to allocate IP addresses to pods. For more information, see Create and manage a vSwitch. If no vSwitch is available, click Create vSwitch to create one. You can select up to three vSwitches that are deployed in different zones. For more information, see Configure a static IP address, a separate vSwitch, and a separate security group for each pod. This allows you to manage and isolate user traffic, configure network policies, and manage IP addresses in a fine-grained manner. The Terway Trunk elastic network interface (ENI) feature allows you to specify a static IP address, a separate vSwitch, and a separate security group for each pod. To use the Support for ENI Trunking feature, you need to log on to the Quota Center console and submit an application. Select or clear Support for ENI Trunking.This prevents Kubernetes network policies from overloading the Kubernetes API server. If you clear Support for NetworkPolicy, you cannot use Kubernetes network policies to control the communication among pods.If you select Support for NetworkPolicy, you can use Kubernetes network policies to control the communication among pods. By default, Assign One ENI to Each Pod is unselected. The NetworkPolicy feature is available only when you clear Assign One ENI to Each Pod.Select or clear Support for NetworkPolicy. On the Managed Kubernetes page, configure the basic settings and advanced settings of the cluster. In the upper-right corner of the Clusters page, click Create Kubernetes Cluster. In the left-side navigation pane, click Clusters. If you want to add more route entries to the VPC of your ACK cluster, request a quota increase for the VPC.īy default, you can create at most 100 security groups with each account.īy default, you can create at most 60 pay-as-you-go SLB instances with each account.īy default, you can create at most 20 EIPs with each account.įor more information about the billing rules of ACK clusters, see Billing. VPCs of ACK clusters that run Terway do not have this limit. After an ECS instance is created, you can change its billing method from pay-as-you-go to subscription in the ECS console.Ĭhange the billing method of an ECS instance from pay-as-you-go to subscriptionīy default, you can add at most 200 route entries to the VPC of an ACK cluster that runs Flannel. The pay-as-you-go and subscription billing methods are supported. Links for increasing quota limits/references ACK is activated and ACK authorization is completed.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |